When your Maytag Bravos XL dryer does not function properly, some checks are recommended before involving a professional service provider. In this all-encompassing guide, we are going to take you through some of the most basic troubleshooting procedures for a Maytag Bravos XL broken-down dryer.

Common Troubleshooting Steps

• Check the power cord: Ensure that the power cord has been plugged into an active outlet and the outlet has been switched on. Similarly, you can switch off the dryer for some time and even check another socket.
• Check the lint screen: Your dryer may fail to heat optimally, due to a clogged lint screen, while simultaneously causing damage resulting in overheating. Wipe clean lint screen after each use.
• Check the vent hose: The vent hose takes the hot air of the dryer out into the environment. A blocked or closed vent hose will result in an improper function of the dryer. Check the vent hose for blockages or kinks and clear the obstructions, if there are any.
• Check the circuit breaker: As the first cause, if your dryer fails to turn on, then check the circuit breaker to ensure that it did not trip. Reset the circuit breaker if it has been tripped. Then turn the dryer on again.
• Check the door switch: The door switch, therefore, closes the dryer door before allowing the unit to start. A defective door switch may cause failure of the dryer to come on. You can also use the door switch to verify whether it is working or not. Simply close the dryer door and press the start button. The door switch may have been damaged and should be replaced if the dryer fails to start.
• Check the thermal fuse: The thermal fuse is a safety device that shuts off or trips the circuit breaker if the dryer overheats. In case the thermal fuse blows, you will have to replace it.
• Check the heating element: Heating of the air in the dryer is done by the heating element. The heating element will have to be replaced should it get burnt out while operating.
• Check the belt: A belt turns off the drum within a dryer. However, when the belt breaks or wears down, it should also be changed.
• Check the motor: The motor serves to rotate the drum as well as the blower fan in the dryer. In case the motor is bad a new one has to be installed.

Troubleshooting Specific Problems

Dryer Is Not Turning On

In case the dryer does not turn on, you can check the power cord, circuit breaker as well and door switch. However, if all this works, then the problem could be from the motor control board. The motor control board controls the motor as well as others in the dryer. In case there is a problem with the motor control board, then it should be substituted.

The Dryer Is Not Heating

Ensure that you inspect and replace the lint screen or vent hose whenever your dryer fails to heat. If everything else is working fine, the issue might lie in the thermostat. The thermostat adjusts the temperature inside the dryer. If the thermostat does not operate properly then it should be changed.

Dryer Is Not Drying Clothes Fast Enough

In case your machine takes more time to dry clothing, inspect the lint screen, vent, and belt. Therefore an individual should examine whether all the above-stated issues are in order before they conclude that there is a problem with the heating element or thermostat. The replacement of the heating element as well as the thermostat if they are not working properly.

Dryer Is Making Strange Noises

When your dryer starts creating weird sounds, pay attention to the drum, belt, and motor. Replacement should be done every time one of these parts experiences damage or wears out.

Dryer Is Overheating.

To correct the overheating dryer, inspect the lint screen, vent hose, and thermal fuse. The other reasons that need to be checked if nothing else is wrong include the thermostat and the heating element. The thermostat or a bad heating element must certainly be changed if it is so.

Ensure that you check through all the above and still the model doesn’t function well, then it is necessary to call for a repair service provider.

Additional Tips

Here are some tips for your Maytag Bravos XL Dryer:

• The clean lint screen before every usage.
• Clean the vent hose at least once in a couple of years.
• Do not overload the dryer.
• Tumble dryers use a series of dryer balls to assist in drying up more quickly and avoid wrinkle formation.

You should ensure that your dryer is inspected and serviced at least every year by an experienced specialist.

Safety Precautions

• The dryer should always be disconnected when servicing.
• Handle with care; the heating element may be very hot.

If you do not feel like repairing the dryer on your own, look for a professional appliance technician.

Conclusion

However, if your Maytag’s Bravos XL dryer does not operate, you can perform certain checks before inviting a technical service worker. The guide gives troubleshooting steps that may assist you to do it by yourself. However, in case the servicing of the dryer does not suit you, or when you have found all the above-mentioned solutions, but the dryer does not function, you should call in a good specialist.

Additional Tips

Here are some additional tips to help keep your Maytag Bravos XL dryer running smoothly:

• Clean the lint screen after every use.
• Wash the vent hose annually or after two years.
• Do not overload the dryer.
• Dryer balls will help your clothes dry quickly and prevent them from wrinkling.
• Once a year, get your dryer serviced by an experienced professional.

If you adhere to these guidelines, the life span of your Maytag Bravos XL dryer will be extended and it will continue to function effectively.

FAQs for Maytag Bravos XL Dryer Not Working

Q: What could be wrong with my Maytag Bravos XL dryer, and why won’t it start?

A: A couple of possible causes for your Maytag Bravos XL dryer refusing to switch on have been listed below. The most common reasons are:

• The problem might lie in the absence of a connection or a faulty power cord.
• The circuit breaker is tripped.
• The door switch is faulty.
• The motor is having problems.

Q: Why did my Maytag dryer stop heating?

A: Below are some reasons why your Maytag Bravos XL dryer cannot heat. The most common reasons are:

• The lint screen is clogged.
• Vent clogging or kinking.
• The thermal fuse is blown.
• It’s just a defective electric burner, nothing else.
• The thermostat is faulty.

Q: What could be causing the delay of a Maytag Bravos XL dryer?

A: The reason that your Maytag appliance is drying out your garments slowly can be attributed to a couple of things. The most common reasons are:

• The lint screen is clogged.
• It may be that the vent hose is blocked or kinked.
• The leather of the belt is torn, or it has got broken.
• The heating element is faulty.
• The thermostat is faulty.

Q: What may be causing my Maytag Bravos XL dryer to sound weird?

A: Some of the causes for weird sounds coming out of this machine include. The most common reasons are:

• The drum is rattling.
• This suggests that the belt is either worn out or broken.
• The motor is faulty.

Q: What is causing my Maytag Bravos XL dryer to overheat?

A: Why your Maytag Bravos XL dryer might be overheating? The most common reasons are:

• The lint screen is clogged.
• The blockage of the vent hose.
• The thermal fuse is blown.
• The thermostat is faulty.

Q: How can I fix my Maytag Bravos XL dryer that isn’t functioning properly?

A: If the Maytag Bravos XL dryer does not work right, follow these troubleshooting techniques.

• Ensure that the power cord is fitted on the right to the socket.
• Ensure that the circuit breaker is not tripped.
• Ensure that the door switch is in good condition.
• Check if there are any blockages or wrinkles on the vent hose.
• Ensure the thermal fuse is all right and replace it when necessary.
• Check the heating element and change it, if needed.
• Test the thermostat for replacement of it, if it is necessary.

Once you have done all that and your Maytag Bravos Dryer is still not operating properly, it is better to call a well-trained repair man or woman.

Q: What are some ways that an individual may prolong the durability of a Maytag Bravo XL dryer?

A: However, here are some tricks that should be done to prolong the life of the Maytag Bravos XL dryer:

• Wipe off the lint screen after every use.
• Replace and clean the vent hose once every one or two years.
• Do not overload the dryer.
• Dryer balls help reduce wrinkles and dry up clothes.
• Get your dryer serviced by an expert every year.